INTEL TRUE SCALE FABRIC BLADE SWITCH 12100 DRIVER DETAILS:
|File Size:||6.6 MB|
|Supported systems:||Windows Vista (32/64-bit), Windows XP (32/64-bit), Windows 8, Windows 10|
|Price:||Free* (*Free Registration Required)|
INTEL TRUE SCALE FABRIC BLADE SWITCH 12100 DRIVER
Form Factors and Interfaces Over the last few years, high-speed serial buses, or switch fabrics, have replaced older, slower, and cumbersome parallel interfaces in embedded designs.
Most of them have not lasted. PCI Express is a serial bus which allows data to be sent in two directions at the same time, doubling the effective bandwidth.
It is used both as a motherboard-level interconnect and as an expansion card interface for addin boards. In medical and military applications, higher bandwidth is needed for manipulating data and for Ethernetbased communications, as more and more systems and subsystems become networked and requirements for high-speed, multiple Gigabit Ethernet connectivity increases. Existing solutions have included a growing array of small board form factors and interfaces.
The second is to construct taller, stacked-board systems based on stackable architectures such as Embedded Platform for Industrial Computing EPICat 4. VDC expects a compound annual growth rate of 9.
Intel True Scale Fabric Blade Switch 12100 SUMIT Solution Instead of assigning one connector per bus, and instead of defining yet another board form factor for next-generation, low-power, highperformance, small board-based systems, it makes more sense to separate the interconnect standard from the form factor standard, and design a new interface that integrates and consolidates both high- and low-speed serial and legacy buses. Keeping the same form factors, and updating only the interfaces, lets form factor standards and interface standards evolve separately.
When a new form factor becomes available, it can support all of those interfaces, which helps minimize revisions to the specifications and increases the design platform s longevity. The interconnect technology chosen for the open standard SUMIT interface accommodates multiple high- and low-speed buses in a single high-speed connector SUMIT-A At the same time, the strong drive toward smaller board sizes and the flexibility needed for a platform to serve multiple uses means that a taller, Figure 3: They must be able to handle the high-frequency signals required by PCI Express and USB, and must be available off-theshelf as a standard product. They must have closely-spaced, fine-pitch pins in order to minimize the board Intel True Scale Fabric Blade Switch 12100 consumed.
Find GUID of Intel® True Scale Fabric Switch Products
Either or both connectors can be used on a board. Another optional connector offers support for legacy ISA devices.
- Purchasing the Intel® True Scale Fabric Edge Switch Port Upgrade
- Downloads for Intel® True Scale Fabric Switch Products
- SNMP MIB for Intel 12300 InfiniBand TrueScale switches
The specification is designed to optimize cost per pin, pin density, and signal integrity. It is also designed to be processor-independent, since it focuses on bus and interconnect technology rather than on a particular processor. This message requires no action.
Driver/BIOS更新情報 年7月第4週分 - AKIBA PC Hotline!
Why is the Switch Log Reporting: The switch is occasionally logging the following in the log file: Thread "tChFanWkr01" 0xccbd1e08 Osa: Thread "tSlot" 0x82b06d40 Osa: Thread "tChPwrWkr01" 0xccbca Osa: Board is operating using manufacturing debug settings Additionally, the Embedded Subnet Manager ESM may not be operational resulting in attached devices stuck in Init state. This indicates that the switch is in the manufacturing mode.
To correct the issue, a serial connection to the switch is required. After the serial connection is established, reboot the switch. Support information for Intel® True Scale Fabric Blade Switch BLc QLogic 4X QDR IB Switch with Management Module installed.